1.A structure of lever type gripping is designed to reduce the cost under the premise of accuracy.

2.A sheet metal is installed between the finger and body to reduce abrasion and extend the service life.

3.The contact area between finger and body is enlarged to reduce shaking and enhance the gripping accuracy.

4.The finger clamps when the piston rod pushes out and stretches when the piston rod retracts.
   The gripping force is 20%~30% greater than the tensile force.

5.Can be mounted from three directions.

6.Magnet is included in the standard configuration.

Installation & Usage

1.Due to the abrupt changes, the circuit pressure is low, which will lead to the decrease of the gripping force and falling of the work-pieces.
   In order to avoid the harm to the human body and damage to the equipment, anti-dropping device must be equipped.
2.Don't use the air gripper under strong external force and impact force.
3.When install and fix the air gripper, avoid falling down, collision and damage.
4.When fixing the gripping jaw parts, don't twist the gripping jaw.
5.There are several kinds of installation method, and the locking torgue of fastening screw must be within the prescribed torque range
   shown in the below chart. If the locking torque is too large, it will cause the dysfunctional.
   If the locking torque is too small, it will cause the position deviation and fall.